Ford Kent Based, Crossflow, Twin Cam / X-Flow (Cross flow) - Side Entry
A product from the A-Series Development team
Race / Competition Use Advance Curves - Non Vacuum Advance
Our advance curves are a great starting point and for many applications will be as close to perfect as possible. A full rolling road session will help to tailor your ignition to your vehicle.
These Distributors are also known as Lucas 43D (43D4)
Please see our electronic distributor fitting guide and data sheet
Take Electronic Ignition one stage further with our Latest Signature Module - intelligent dwell control and heat management.
A-Series Spares can now offer solid state electronic distributors for Kent based Lotus Twin Cam (62-75), Ford Pre-Crossflow (67-69) and Ford Crossflow (67-75) 4-cylinder engines.
This advert is for the side-entry Ford Crossflow distributor, this is ideal for the applications using twin Weber Carburetor's
This distributor has been set up for race / competition engines where good spark control is required over the full rev range. This unit has been designed and built for competition engines for reliability and performance.
The Ford Kent engine has been used in many different production cars through the years aswell as many kit cars and performance cars such as Lotus 7 and Caterham's
This unit is built without a vacuum advance unit, for these models only the casting is original. These use our latest internal parts:
-
A-SD Developed fixed breaker plate
-
Different advance weights and springs
-
A-SD Developed cover plate
Complete with a 24 month warranty.
43D Applications List
|
|
Benefits of our Electronic Distributors
|
|
Ford
Capri MK1, Capri MK2, Capri MK3
Escort MK1, Escort MK2, XR3
Fiesta MK1, XR2
1962 - 1974 Lotus Elan
1963 - 1964 Lotus Cortina
1964 - 1966 Lotus Cortina
1967 - 1970 Ford Cortina Twin Cam
1968 - 1970 Ford Escort Twin Cam
1968 - Formula Ford Motor Racing
1972 - 1975 Lotus Europa Type 74
1973 - 1974 Caterham Super Seven
There are many other applications for this distributor, if unsure please contact our sales team
|
|
Improved performance
- Easier starting
- Up to 15% better fuel economy
- Improved ignition
- Improved fuel economy
- Easy PLUG & PLAY installation
- No adjustments needed
System Requirements
- 12v non Ballast Negative Earth
- Standard ignition coil with <1.5 Ohms resistance
- Only to be used with surpressed HT leads
Simple wiring involves Red wire connecting to the positive connector on the coil and the Black connecting to the negative side
Warning:
Make sure not to reverse the RED and BLACK Ignition wires as this is likely to destroy the ignition module and void the warranty. Returned units are tested to identify the cause of failure.
Using a coil with too little primary resistance can cause the ignition module to overheat and fail also voiding the warranty. Please contact a member of our team if you are unsure of any details. All ignition products supplied by A-Series Spares come with a 2 year manufacturers warranty |
For further information, please email sales@aseriesspares.co.uk
Alternatively call our sales team free on 0800 8 247 294
